I promise you, this display cabinet only cost us $28.00 from start to finish. Les Gains, my husband, makes things. Lots and lots of little things. If he does not have a guitar in his hands, then you will find him in his studio creating fabulous little treasures.
Above is a crowd of funny little guys that Les made with resin. He first sculpts figures out of modeling clay, then he makes molds, then pours resin into the molds. When the resin has set up, Les unmolds them and then paints each figure. THEN he assembles his elements into really cool little sculptures. As much as I am fascinated by his work, a lot of little things spread all over the house drives me nuts. I like to group small things together to form a larger display unit.
Several years ago, I bought two of these cabinets from IKEA. The photo on the left shows the cabinet with the clear glass door open. Sporting adjustable shelves, it is perfect for small collectibles. Generally, Les works small. Most of his items range in height from 1″ to 9″.
As prolific as he is, the IKEA cabinets were full in no time at all. I needed a larger display shelf that would compliment the style of the old cabinet and our eclectic home decor.
So, off we went on yet another mission. Seeking cheap building materials, Les and I scoured junk yards and thrift stores. We finally found exactly what we needed at Khules, a salvage store in Prescott.
From the salvage yard, we bought a large galvanized utility box. Probably some type of electrical junction box? After finding the box, the rest was easy to assemble.
This photo shows the larger, finished box and a close up on the right so that you can see the side detail. It’s easy to make – just follow our step-by-steps listed here.
- (after a thorough cleaning) Drill holes into the sides of the box. You will need two sets of holes on each side of the box for each shelf.
- Cut 2 rods for each shelf that extend past the sides of the box. Thread them into the holes cross ways.
- Cut plastic shelves to fit inside the cabinet. I also bound the edges with copper tape and used an antiquing solution to age the tape.
- Finally, we got little caps to finish off the raw edges of the rods that stuck out of the cabinet sides. The whole assembly only cost only $28.00
Here are a few of Les’ sculptures. He solders, shapes wire, polymer clay, resin and found objects to make wonderfully detailed figures.